Option Descriptioncontroller and disable it on the other controllers. Thesystem can then boot from the BIOS-enabled controller.Enable BIOS Stop On Error Select the option to stop the system BIOS during bootup ifthere are BIOS errors. The option enables you to enter theconfiguration utility to resolve the problem.Select Bootable Device Select the option to specify a virtual disk as the boot diskon the controller.NOTE: For PERC H310 the option may be a Virtual Diskor Non-RAID drive.The option is displayed if you have built virtual disks.Enable Auto Import Attempts to import every online foreign configurationduring boot without having the need to access the BIOSConfiguration Utility ( ).Factory Default Select the option to restore the default settings for theoptions in the Settings box.Foreign Configuration ViewWhen a foreign configuration is present, you can select Foreign Configuration View to display the configuration. Thescreen shows the foreign configuration as it would be if you import it. You can preview the foreign configuration beforeyou decide whether to import it or clear it.In some cases, a foreign configuration cannot be imported. If a physical disk in a virtual disk is rebuilding, the physicaldisk's state is set to Rebuild. No virtual disk target ID displays for virtual disks that cannot be imported.The section Importing or Clearing Foreign Configurations Using the Foreign Configuration View Screen contains theprocedures you can use to manage the foreign configurations.NOTE: The BIOS Configuration Utility ( ) reports error codes for failed imports of foreign configurations.Physical Disk ManagementSetting LED BlinkingThe LED blinking option indicates when physical disks are being used to create a virtual disk. You can choose to start orstop the LED blinking.Perform the following steps to start or stop the option:1. Press to access the PD Mgmt screen.A list of physical disks is displayed. The status of the each disk is displayed under the heading State.2. Press the down-arrow key to highlight a physical disk.3. Press to display the menu of available actions.4. Press the down-arrow key to highlight LED Blinking.5. Press the right-arrow key to display the available actions, Start and Stop.6. Select Start to begin LED blinking or Stop to end LED blinking.54
