CorrectiveAction: The issue occursbecause of any ofthe followingcauses:• The driver is not native in the operating system.To resolve the issue, press to install the RAID devicedriver during installation.• The virtual disks are not configured properly.To resolve the issue, enter the BIOS Configuration Utility( ) to configure the virtual disks. For procedures toconfigure the virtual disks, see the topic ManagementApplications For PERC Cards.• The controller BIOS is disabled.To resolve the issue, enter the BIOS Configuration Utility( ) to enable the BIOS. For information onconfiguring virtual disks, see the topic ManagementApplications For PERC Cards.Physical Disk IssuesPhysical Disk In Failed StateIssue: One of the physical disks in the disk array is in the failed state.CorrectiveAction:Update the PERC cards to the latest firmware available on dell.com/support.Unable to Rebuild A Fault Tolerant Virtual DiskIssue: Cannot rebuild a fault tolerant virtual disk. For more information, see the alert log for virtualdisks.CorrectiveAction:The replacement disk is too small or not compatible with the virtual disk. Replace the faileddisk with a compatible good physical disk with equal or greater capacity.Fatal Error Or Data Corruption ReportedIssue: Fatal error(s) or data corruption(s) are reported when accessing virtual disks.CorrectiveAction:Contact Dell Technical Support.Physical Disk Displayed As BlockedIssue: One or more physical disks is displayed as Blocked and cannot be configured.CorrectiveAction:Update the PERC cards to the latest firmware available on dell.com/support.79
