• The controller detects an Error-Correcting Code (ECC) error while performing its cachechecking routine during initialization.• The controller discards the cache rather than sending it to the disk subsystem becausethe data integrity cannot be guaranteed.CorrectiveAction:To resolve this issue, allow the battery to charge fully. If the problem persists, the battery orcontroller memory may be faulty; contact Dell Technical Support.Missing Disks In Virtual Disk Error MessageError Message: The following virtual disks have missing disks: (x). If youproceed (or load the configuration utility), these virtualdisks will be marked OFFLINE and will be inaccessible. Pleasecheck your cables and ensure all disks are present. Press anykey to continue, or 'C' to load the configuration utility.Probable Cause: The message indicates that some configured disks were removed. If the disks were notremoved, they are no longer accessible. The SAS cables for your system might be improperlyconnected.CorrectiveAction:Check the cable connections and fix any issues. Restart the system. If there are no cableproblems, press any key or to continue.Previous Configuration Of Disks Removed Error MessageError Message: All of the disks from your previous configuration are gone. Ifthis is an unexpected message, then please power off yoursystem and check your cables to ensure all disks are present.Press any key to continue, or press to load theconfiguration utility.Probable Cause: The message indicates that some configured disks were removed. If the disks were notremoved, they are no longer accessible. The SAS cables for your system might be improperlyconnected.CorrectiveAction:Check the cable connections and fix any issues before restarting the system. If there are nocable problems, press any key or to continue.Missing Virtual Disks Error MessageError Message: The following virtual disks are missing: (x). If you proceed(or load the configuration utility), these virtual disks willbe removed from your configuration. If you wish to use them ata later time, they will have to be imported. If you believethese virtual disks should be present, please power off yoursystem and check your cables to ensure all disks are present.Press any key to continue, or 'C' to load the configurationutility.Probable Cause: The message indicates that some configured disks were removed. If the disks were notremoved, they are no longer accessible. The SAS cables for your system might be improperlyconnected.72
