182 Adding and Replacing Parts10 Lift the display assembly from the base, and place the display assembly toone side.Installing the Display Assembly1 Place the display assembly on the base.2 Feed the Mini-Card antenna cables from the top through the antennachannel to the bottom of the system.Align the shrink tube that is wrapped around the antenna cables to theedge of the palm rest. Make sure the antenna cables are flat (containedwithin the recessed area) and do not overlap. Secure the antenna cableswith the tape that was removed from the cables when removing the displayassembly.NOTE: If the cables do not lie flat in the recessed area or if they overlap the palmrest, then the keyboard will not sit flat on the palm rest.1 M2.5 x 5-mm screws (2)1
