System Setup ScreensNOTE: For information about a specific item on a system setup screen, highlight the item and see the Help area onthe screen.In the system setup program, primary categories of settings are listed on the left. To view the types ofsettings in a category, highlight the category and press . When you highlight a setting type, theright side of the screen displays the value for that setting type. You can change settings that appear aswhite type on the screen. Values that you cannot change (because they are determined by the computer)appear less bright.System-setup key functions are listed across the bottom of the screen.Commonly Used SettingsCertain settings require that you reboot the computer for new s e ttings to take effect.Changing the Boot SequenceThe boot sequence tells the computer where to look to find the software needed to start the operatingsystem. You can control the boot sequence and enable/disable devices using the Boot Sequence page,which is located in the System category.NOTE: To change the boot sequence on a one-time-only basis, see "Performing a One-Time Boot" on page 95.The Boot Sequence page displays a general list of the bootable devices that may be installed in yourcomputer, including but not limited to the following:• Diskette Drive• Modular bay HDD• Internal HDD• CD/DVD/CD-RW driveDuring the boot routine, the computer starts at the top of the list and scans each enabled device for theoperating system start-up files. When the computer finds the files, it stops searching and starts theoperating system.To control the boot devices, select (highlight) a device by pressing the down-arrow or up-arrow key, andthen enable or disable the device or change its order in the list.• To enable or disable a device, highlight the item and press the space bar. Enabled items appear as whiteand display a small triangle to the left; disabled items appear blue or dimmed without a triangle.• To reorder a device in the list, highlight the device and then press or (not case-sensitive) tomove the highlighted device up or down.Boot sequence changes take effect as soon as you save the changes and ex it the system setup program.94 System Setup Program
