Configuring the PowerConnect 3324/3348 Switch 53To configure SNMP station IP address and community string(s):1 At the console prompt, type Enable. The prompt is displayed as #.2 Type configure and press .3 In the configuration mode, type the SNMP configuration command with theparameters including community name (private), community access right (read andwrite) and IP address, as shown in the example below:console> enableconfig# configureconfig(config)# snmp-server community private rw 11.1.1.2config(config)# exitconfig# show snmpCommunity-String Community-Access IP address-------------------- ---------------- ---------------private readWrite 11.1.1.2Traps are enabled.Authentication-failure trap is enabled.Trap-Rec-Address Trap-Rec-Community Version---------------- -------------------- -------System Contact:System Location:This completes the initial configuration of the device from a local terminal. The configuredparameters enable further device configuration from any remote location.Advanced ConfigurationThis chapter contains information about dynamic allocation of IP addresses and securitymanagement based on the AAA (authentication, authorization and accounting)mechanism. The chapter includes the following topics:• Configuring IP Addresses through DHCP.• Configuring IP Addresses through BOOTP.• Security Management and Password Configuration.
