Configuring the PowerConnect 3324/3348 Switch 81Downloading the Software Sequentially Using the CLI1 Ensure that an IP address is assigned to at least one port on the Master unit.2 Enter console# show version to verify which software version is currently runningon each unit. The following is an example of the information which displays:Unit SW version Boot version HW version----------------------------------------------------1 1.0.0.52 1.0.0.13 00.00.012 1.0.0.52 1.0.0.13 00.00.01Each unit’s software version, boot version, and hardware version are displayed. In theabove example, the units’ boot versions and hardware versions differ, while thesoftware version is the same.3 Enter console# show bootvar to verify which image version is active on whichunit. The following is an example of the information which displays:Unit Active image Selected for next boot-----------------------------------------------------1 image-2 image-22 image-1 image-1Both the active Image file and the Image file that is active after the device is reset aredisplayed for all units.4 Enter console# copy tftp://{tftp address}/{file name} image to copythe software to the Master unit. The file is copied but does not become active untilthe file is selected as the Active Image file after the device is reset. The following is anexample of the information that displays:console# copy tftp://176.215.31.3/332448-10018.dos imageErasing file image-1...done.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!NOTE: Each ! indicates that ten packets were successfully transferred.Copy: 2739187 bytes copied in 00:01:13 [hh:mm:ss]
