108 Address Table Commandsw w w . d e l l . c o m | s u p p o r t . d e l l . c o mD E L L C O N F I D E N T I A L – P R E L I M I N A R Y 9 / 1 3 / 0 6 – F O R P R O O F O N LYport security maxThe port security max Interface Configuration (Ethernet, port-channel) mode commandconfigures the maximum number of addresses that can be learned on the port while the port isin port security mode. To return to the default configuration, use the no form of this command.Syntaxport security max max-addrno port security max• max-addr— Maximum number of addresses that can be learned by the port.(Range: 1-128)Default ConfigurationThe default setting is 1 address.Command ModeInterface Configuration (Ethernet, port-channel) modeUser GuidelinesThis command is only relevant in dynamic learning modes.ExampleIn this example, the maximum number of addresses that are learned on port 1/e7 before it islocked is set to 20.port security routed secure-addressThe port security routed secure-address Interface Configuration (Ethernet, port-channel) modecommand adds a MAC-layer secure address to a routed port. Use the no form of this commandto delete a MAC address.Syntaxport security routed secure-address mac-addressno port security routed secure-address mac-address• mac-address — A valid MAC address.Console(config)# interface ethernet 1/e7Console(config-if)# port security mode dynamicConsole(config-if)# port security max 20
