802.1x Commands 451D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 9 / 1 3 / 0 6 – F O R P R O O F O N LYADVANCED FEATURESdot1x auth-not-reqThe dot1x auth-not-req Interface Configuration mode command enables unauthorized devicesaccess to the VLAN. To disable access to the VLAN, use the no form of this command.Syntaxdot1x auth-not-reqno dot1x auth-not-reqDefault ConfigurationAccess is enabled.Command ModeInterface Configuration (VLAN) modeUser Guidelines• An access port cannot be a member in an unauthenticated VLAN.• The native VLAN of a trunk port cannot be an unauthenticated VLAN.• For a general port, the PVID can be an unauthenticated VLAN (although only tagged packetswould be accepted in the unauthorized state.)ExamplesThe following example enables access to the VLAN to unauthorized devices.EapolReqFramesTx The number of EAP Request frames (other than Rq/Id frames) thathave been transmitted by this Authenticator.InvalidEapolFramesRx The number of EAPOL frames that have been received by thisAuthenticator in which the frame type is not recognized.EapLengthErrorFramesRx The number of EAPOL frames that have been received by thisAuthenticator in which the Packet Body Length field is invalid.LastEapolFrameVersion The protocol version number carried in the most recently receivedEAPOL frame.LastEapolFrameSource The source MAC address carried in the most recently received EAPOLframe.Console(config-if)# dot1x auth-not-req
