Dell PowerConnect 55xx Systems User Guide 355– Active Image — The name of the image file that is currently active onthe unit in the stack.– After Reset — The image file that will be active on the unit in thestack after the device is reset. The possible options are:• Image 1 — Activates Image file 1 after the device is reset.• Image 2 — Activates Image file 2 after the device is reset.2 Click Apply to select the image file to be used after reset in After Reset.Working with the Active Image File Using CLI CommandsThe following table summarizes the CLI commands for viewing fieldsdisplayed in the Active Images.The following is an example of the CLI commands:Copy FilesFirmware and configuration files can be copied between units in the stack.Use the Copy Files page to perform the following:• Copy the firmware on the Master unit to another unit in the stack.• Copy the master Running Configuration file to the master sTartupConfiguration file, or copy the configuration to a user-definedconfiguration file.• Copy the master Startup Configuration file to a backup file on the Flashfile system or to a USB if available.Table 9-66. Active Image CLI CommandsCLI Command Descriptionboot system {image-1|image-2} [switchnumber|all]Sets the system image that the device loads atstartup.show version [unitunit]Displays version information for the systemconsole# boot system image-1 all
