| 
support.dell.com Installing and Configuring SCSI Drivers 3-5 !"#To install NetWare 5.1 SCSI drivers from the NetWare 5.1 SCSI driver diskette thatyou created, perform the following steps:1. At the initial NetWare screen, press to display the NetWare consolescreen.2. At the server prompt, type nwconfig and press .The NetWare Configuration screen appears, displaying the ConfigurationOptions menu.3. At the Configuration Options menu, highlight Driver Options and press.4. At the Driver Options menu, highlight Configure disk and storage devicedrivers and press .5. At the Additional Driver Actions menu, highlight Load an additional driver andpress .The software scans the system to determine what drivers are already installed.6. When the Select a driver menu appears, insert the NetWare 5.1 SCSI driver dis-kette into the diskette drive and press to install an unlisted driver.7. Read the instructions on the screen and press to continue.8. At the Select a driver to install menu, highlight a desired driver and press.9. When you are prompted to confirm, highlight Yes and press .10. To accept the default server boot path that is displayed, press .The software copies the driver to the selected location.11. At the Driver xxx Parameter Actions screen, highlight Select/Modify driverparameters and press .12. At the driver parameters screen, type 1 for the integrated SCSI adapter or enterthe slot number of the SCSI adapter card.NOTE: The integrated SCSI adapter is always assigned to slot 1. If an adapter cardis installed in slot 1, you must specify it as being in slot 2. An adapter cardinstalled in slot 2 or a higher numbered slot is assigned its true physical slotnumber.13. Press to save the parameters and exit.14. At the Driver xxx Parameter Actions screen, highlight Save parameter andload driver and press .15. At the NetWare Configuration screen, confirm that the new driver has beenadded to the list that is displayed. |
