4-6 User’s Guide You can set the following security features through the System Security screen: Password Status — when Setup Password is set to Enabled, allows you toprevent the system password from being changed or disabled at system start-up.To lock the system password, you must first assign a setup password in theSetup Password option and then change the Password Status option toLocked. In this state, the system password cannot be changed through theSystem Password option and cannot be disabled at system start-up by pressing.To unlock the system password, you must enter the setup password in theSetup Password option and then change the Password Status option toUnlocked. In this state, the system password can be disabled at system start-upby pressing and then changed through the System Passwordoption. System Password — displays the current status of your system's passwordsecurity feature and allows you to assign and verify a new password.NOTE: See the section “Using the System Password Feature” found later in thischapter for instructions on assigning a system password and using or changing anexisting system password. See the section, “Disabling a Forgotten Password”found later in this chapter for instructions on disabling a forgotten systempassword. Setup Password — lets you restrict access to your computer's System Setupprogram in the same way that you restrict access to your system with the sys-tem password feature.NOTE: See the section “Using the Setup Password Feature” found later in thischapter for instructions on assigning a setup password and using or changing anexisting setup password. See the section “Disabling a Forgotten Password”found later in this chapter for instructions on disabling a forgotten setuppassword. Chassis Intrusion — lets you enable the system chassis intrusion switch todetect if the system cover is removed. If this option is set to Enabled, a warningmessage is displayed during system startup. If the option is set toEnabled – Silent, no Startup message is displayed, but the Chassis Intrusionoption in the System Setup program will change to Detected.! After you press to exit the System Setup program, the Exit screen displays thefollowing choices: Save Changes and Exit Discard Changes ad Exit Return to Setup
