|
3-6 User’s Guide16. Repeat steps 3 through 15 for any additional drivers you want to install.17. Press three times. At the Exit nwconfig? dialog box, highlight Yes andpress .If you need additional assistance, see the section “Troubleshooting for NetWare”found later in this chapter. !" #The BIOS for the integrated Adaptec AIC-7899 SCSI controller includes the menu-driven SCSISelect configuration utility, which allows you to change SCSI controllersettings without opening the computer. SCSISelect also contains SCSI disk utilitiesthat let you low-level format or verify the disk media of your SCSI hard-disk drives. % &You can start the SCSISelect utility by pressing when the following promptappears briefly during start-up:Press for SCSISelect™ Utility!The first menu displays the Configure/View Host Adapter Settings and SCSI DiskUtilities options. % 'SCSISelect uses menus to list options that you can select. To select an option, pressthe up- and down-arrow keys to move the cursor to the option; then press .In some cases, selecting an option displays another menu. You can return to the previ-ous menu at any time by pressing . To restore the original SCSISelect defaultvalues, press . % ' Default settings for the integrated AIC-7899 SCSI controller are shown in Table 3-1.These default settings are appropriate for most Peripheral Component Interconnect(PCI) systems. Run SCSISelect only if you need to change any of the default settings.NOTES: To change the configuration settings, you must run the SCSISelect Utility.The term host adapter is used throughout this file to refer to the integrated AIC-7899SCSI controller.If the host adapter does not control the bootable hard-disk drive, you may want to dis-able its BIOS.For situations in which you might want or need to change the settings, see thedescriptions of each setting in the following subsections. PreviousNext |