Installing System Components 77Installing the Diskette Drive Into the Drive CarrierPlace the diskette drive into the drive carrier with the connectors toward the back, align the screw holes,and secure with the three Phillips screws. See Figure 3-17.Figure 3-17. Installing the Diskette Drive Into the Drive CarrierInstalling the Diskette DriveCAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.1 Turn off the system, including any attached peripherals, and disconnect the system from theelectrical outlet.2 Remove the front bezel, if attached. See "Removing the Bezel" on page 46.3 Open the system. See "Opening the System" on page 48.4 If a diskette drive ribbon cable is already connected to your system board, skip to the next step.Otherwise, do the following:a Disconnect the cables from the SAS controller card (see Figure 3-13) or the SAS RAID controllerdaughter card (see Figure 3-14) and pull the cables out of the way of the center fans.b Remove the fans from the center fan bracket. See "Removing and Installing a Fan" on page 53.c Remove the center fan bracket. See "Removing the Center Fan Bracket" on page 82.1 diskette drive 2 screws (3) 3 plastic latch4 diskette drive carrier421 3book.book Page 77 Tuesday, September 1, 2009 4:19 PM
