Figure 92. Installing the control panel for eight hard drive system1. control panel 2. notch on chassis front wall (2)3. display module ZIF connector 4. display module cableNext stepsFollow the procedure listed in the After working inside your system section.Related LinksAfter working inside your systemRemoving the control panel–eight hard drive systemRemoving the control panel–10 hard drive and 24 hard drive systemPrerequisitesCAUTION: Many repairs may only be done by a certified service technician. You should onlyperform troubleshooting and simple repairs as authorized in your product documentation, or asdirected by the online or telephone service and support team. Damage due to servicing that isnot authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat are shipped with your product.1. Follow the safety guidelines listed in the Safety instructions section.2. Follow the procedure listed in the Before working inside your system section.3. Keep the Philips #1 screwdriver ready.Steps1. Remove the screw (located at the top of the chassis) that secures the control panel to the chassis.2. Remove the control panel cable from the connectors on the system board (J_CP and J_FP_USB) andthe hard drive expander card.168
