Next stepsFollow the procedure listed in the After working inside your system section.Related LinksSafety instructionsSystem board jumpers and connectorsAfter working inside your systemRemoving the control panel–10 hard drive and 24 hard drive systemVGA moduleNOTE: Only the eight hard drive system has a VGA module on the front panel.Removing the VGA modulePrerequisitesCAUTION: Many repairs may only be done by a certified service technician. You should onlyperform troubleshooting and simple repairs as authorized in your product documentation, or asdirected by the online or telephone service and support team. Damage due to servicing that isnot authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat are shipped with your product.CAUTION: The display module connector is a ZIF (zero insertion force) connector. Ensure that thelocking tab on the connector is released before removal and insertion. The locking tab must beengaged after insertion.1. Follow the safety guidelines listed in the Safety instructions section.2. Follow the procedure listed in the Before working inside your system section.3. Keep the Philips #2 screwdriver ready.Steps1. Disconnect the display module cable from the control panel board.2. Remove the control panel.3. Disconnect the VGA module cable from the VGA module.4. Remove the screw that secures the VGA module to the chassis.5. Slide the VGA module out of the chassis.171