Amber LED State Description3,3 no memory modules are detected3,4 possible system board error3,5 memory modules are detected, but a memory configuration or compatibility error3,6 possible system board resource and/or hardware failure3,7 some other failure with messages on screenMemory Beep CodeThe system emits a series of beeps during startup if it detects no memory. The beep code pattern emitted is 1-3-2 (1beep, then 3 beeps, then 2 beeps). The delay between each beep is 300 ms, the delay between each set of beeps is 3secs, and the beep sound lasts 300 ms. Reseating the memory modules may fix the memory errors. After emitting beeps,the BIOS will detect if the user presses the power button and will execute the normal shutdown process and power thesystem off.Troubleshooting System Startup FailureIf you boot the system to the BIOS boot mode after installing an operating system from the UEFI boot mode, the systemhangs. The reverse is also true. You must boot to the same boot mode in which you installed the operating system.For all other startup issues, note the system messages that appear on the screen.Troubleshooting External ConnectionsEnsure that all external cables are securely attached to the external connectors on your system before troubleshootingany external devices.Troubleshooting The Video Subsystem1. Check the system and power connections to the monitor.2. Check the video interface cabling from the system to the monitor.3. Run the appropriate diagnostic test.If the tests run successfully, the problem is not related to video hardware.If the tests fail, see Getting Help.Troubleshooting A USB DeviceUse the following steps to troubleshoot a USB keyboard/mouse. For other USB devices, go to step 7.1. Disconnect the keyboard and mouse cables from the system briefly and reconnect them.2. Connect the keyboard/mouse to the USB port(s) on the opposite side of the system.3. If the problem is resolved, restart the system, enter the System Setup, and check if the non-functioning USB portsare enabled.4. Replace the keyboard/mouse with another working keyboard/mouse.5. If the problem is resolved, replace the faulty keyboard/mouse.64