Dell PowerVault DL4000 Owner's Manual

Also see for PowerVault DL4000: Deployment guide Handbook Deployment guide Release note Getting started guide

Contents

Internal SD CardRemoving An Internal SD CardCAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet andperipherals.2. Open the system.3. Locate the SD card slot on the internal dual SD module or the backplane expander board and press inward on thecard to release it from the slot and remove the card.4. Close the system.5. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.Installing An Internal SD CardCAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.NOTE: To use an SD card with your system, ensure that the internal SD card port is enabled in the System Setup.1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet andperipherals.2. Open the system.3. Locate the SD card connector on the internal dual SD module or the backplane expander board. With the label sidefacing up, insert the contact-pin end of the card into the slot.NOTE: The slot is keyed to ensure correct insertion of the card.4. Press the card into the card slot to lock it into place.5. Close the system.6. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.Integrated Storage Controller CardYour system includes a dedicated expansion-card slot on the system board for an integrated controller card thatprovides the integrated storage subsystem for your system’s internal hard drives. The controller supports SAS and SATAhard drives and also enables you to set up the hard drives in RAID configurations as supported by the version of thestorage controller included with your system.46