Item Indicator, Button, orConnector Icon DescriptionIf the system stops responding during POST, press andhold the system ID button for more than five seconds toenter BIOS progress mode.To reset the iDRAC (if not disabled in F2 iDRAC setup)press and hold the button for more than 15 seconds.6 Mini USB connector Allows you to connect USB devices to the system. Theport is USB 2.0-compliant.7 Hard drives (10) Up to ten 2.5 inch hot-swappable hard drives.8 Information tag A slide-out label panel, which allows you to record systeminformation, such as Service Tag, NIC, MAC address, andso on as per your need.Diagnostic IndicatorsThe diagnostic indicators on the system front panel display error status during system startup.The following section describes system conditions and possible corrective actions associated with these indicators:Electrical indicatorCondition Corrective ActionThe indicator blinksamber if the systemexperiences anelectrical error (forexample, voltage outof range, or a failedpower supply orvoltage regulator).See the System Event Log or system messages for the specific issue.If it is due to a problem with the power supply, check the LED on thepower supply. Re-seat the power supply by removing and reinstallingit. If the problem persists, see Getting Help.Temperature indicatorCondition Corrective ActionThe indicator blinksamber if the systemexperiences athermal error (forexample, atemperature out ofrange or fan failure).Ensure that none of the following conditions exist:• A cooling fan is removed or has failed.• System cover, cooling shroud, EMI filler panel, memory-module blank, or back-filler bracket is removed.• Ambient temperature is too high.• External airflow is obstructed.See Getting Help.8
