Dell PowerVault DL4000 Owner's Manual

Also see for PowerVault DL4000: Deployment guide Handbook Deployment guide Release note Getting started guide

Contents

Installing The Integrated Storage ControllerCAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.2. Open the system.3. Align one end of the card with the card holder on the system board.4. Lower the other end of the card and align the holes on the card with the locating posts of the extractors on thesystem board.5. Press the card down at the corners until it is fully seated.When the card is fully seated, the plastic standoff tab snaps over the edge of the holder.6. Close the system.7. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.Network Daughter CardCAUTION: If the GPU card is installed, you cannot install the 10 GbE network daughter card.Removing The Network Daughter CardCAUTION: Many repairs may only be done by a certified service technician. You should only performtroubleshooting and simple repairs as authorized in your product documentation, or as directed by the online ortelephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by yourwarranty. Read and follow the safety instructions that came with the product.1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.2. Open the system.3. Remove the expansion-card riser 3.4. Using a #2 Phillips screwdriver, loosen the two captive screws that secure the network daughter card to thesystem board.5. Hold the network daughter card by the edges on either side of the touch point and lift to remove it from theconnector on the system board.6. Slide the network daughter card away from the back of the system until the RJ-45 connectors are clear of the slotin the back panel.7. Lift the network daughter card out of the system.48