138 Removing and Installing Parts8 If you are not replacing the drive, replace the drive-panel insert (see"Replacing the Drive-Panel Insert" on page 126).9 Replace the drive panel (see "Replacing the Drive Panel" on page 127).10 Replace the computer cover (see "Replacing the Computer Cover" onpage 172.11 If you are not replacing the drive, then ensure that these changes arereflected in the BIOS. When you restart your computer, enter systemsetup (see "System Setup" on page 178). On the setup screen go to the"Drives" section and under Diskette Drive set the value to "none".Installing a Floppy Drive1 Follow the procedures in "Before You Begin" on page 99.2 Remove the computer cover (see "Removing the Computer Cover" onpage 101).3 Lay the computer on its side so that the system board is on the bottom ofthe inside of the computer.4 Remove the drive panel (see "Removing the Drive Panel" on page 124).5 If installing a new floppy drive, remove the drive panel insert (see"Removing the Drive-Panel Insert" on page 125).6 If you are installing a new floppy drive, remove the shoulder screws fromthe inside of the drive-panel insert and attach the screws to the new drive.See "Removing the Drive-Panel Insert" on page 125.1 floppy drive 2 shoulder screws (4)12book.book Page 138 Tuesday, November 27, 2007 10:29 AM
