Removing and Installing Parts 1058 If you are installing a new CD/DVD drive rather than replacing a drive, remove thefront-panel inserts.From inside the drive bay, gently press on each side of the insert until it pops out.9 If you are installing a drive that has its own controller card, install the controller card inan expansion slot.See the documentation that accompanied the drive and controller card to verify thatthe configuration is correct for your computer..10 Check all cable connections, and fold cables out of the way to provide airflow for thefan and cooling vents.11 Close the computer cover (see page 117).NOTICE: To connect a network cable, first plug the cable into the network wall jack and thenplug it into the computer.12 Connect your computer and devices to electrical outlets, and turn them on.See the documentation that came with the drive for instructions on installing anysoftware required for drive operation.Microprocessor Airflow ShroudCAUTION: Before you perform this procedure, follow the safety instructions onpage 13.Removing the Microprocessor Airflow Shroud1 Follow the instructions in "Before You Begin" on page 80.2 Open the computer cover (see page 82).3 Press down and back on the indentations at the top corners of the shroud.The top anchor tabs disengage from the anchor slots.4 Lift the airflow shroud out of the chassis.G0550bk1.book Page 105 Thursday, July 10, 2003 1:55 PM
