Replacing the Infrared-Emitter Port | 10949 Replacing the Infrared-Emitter PortWARNING: Before working inside your computer, read the safety informationthat shipped with your computer and follow the steps in "Before You Begin" onpage 11. After working inside your computer, follow the instructions in "AfterWorking Inside Your Computer" on page 13. For additional safety best practicesinformation, see the Regulatory Compliance Homepage at dell.com/regulatory_compliance.Procedure1 Slide the infrared-emitter port through the slot on the I/O-board bracket.2 Replace the nut that secures the infrared-emitter port to the I/O-board bracket.Postrequisites1 Follow step 3 to step 7 in "Replacing the I/O Board" on page 101.2 Replace the inner frame. See "Replacing the Inner Frame" on page 97.3 Replace the system-board shield. See "Replacing the System-Board Shield" onpage 33.4 Replace the I/O panel. See "Replacing the I/O Panel" on page 93.5 Replace the trim cover. See "Replacing the Trim Cover" on page 89.6 Replace the stand. See "Replacing the Stand" on page 49.7 Replace the back cover. See "Replacing the Back Cover" on page 21.