Replacing the Camera Module | 14363 Replacing the Camera ModuleWARNING: Before working inside your computer, read the safety informationthat shipped with your computer and follow the steps in "Before You Begin" onpage 11. After working inside your computer, follow the instructions in "AfterWorking Inside Your Computer" on page 13. For additional safety best practicesinformation, see the Regulatory Compliance Homepage at dell.com/regulatory_compliance.Procedure1 Slide the camera module into the camera assembly.2 Tighten the captive screw that secures the camera module and the grounding cableto the camera assembly.3 Connect the camera cable to the camera assembly and place the camera in thecomputer base.4 Replace the screws that secure the camera assembly to the computer base.Postrequisites1 Follow step 8 to step 19 in "Replacing the Display Panel" on page 139.2 Replace the inner frame. See "Replacing the Inner Frame" on page 97.3 Replace the processor heat-sink fan. See "Replacing the Processor Heat-Sink Fan"on page 77.4 Replace the trim cover. See "Replacing the Trim Cover" on page 89.5 Replace the system-board shield. See "Replacing the System-Board Shield" onpage 33.6 Replace the stand. See "Replacing the Stand" on page 49.7 Replace the back cover. See "Replacing the Back Cover" on page 21.
