Ch a pt er 1 0 De vic eN e t Com m unic at i on Mo d ul e A H 10 DN ET1 0 - 3 110.8 Special Operation in Slave Mode10.8.1 Slave Mode and Mapping Areas SettingAH10DNET-5A can be set to the DeviceNet slave through the software. When AH10DNET-5A worksas a slave, the default input/ output length is 8 bytes and maximum input/output data length is 1000bytes.There are two methods of setting AH10DNET-5A to the slave. While the slave mode is being set, thestarting addresses of the mapping areas of AH10DNET-5A can be set simultaneously.Method 1: Setting slave mode and the starting addresses of the mapping areas throughISPSoft and DeviceNet Builder1. PC accesses an AH500 series CPU module via USB after connecting the device according tothe following figure.RS232DeviceNet Builder CPU530-ENPS05P 05S C U530-ENP 10DNETAH10DNET-5ANote: The introduction in this section is made in the USB communication method.2. Open ISPSoft, select “File” >> “New” >> “New” and then the following dialog box appears whereselect the corresponding PLC.Note: The PLC used in this section is AHCPU530-EN.
