Denon AVR-2311 Owner's Manual

Also see for AVR-2311: Service manual Service manual Owner's manual

Contents

10ENGLISHParameter CheckThis function enables you to check the measurement results andequalizer characteristics after Audyssey Auto Setup.1 Use ui to select “Parameter Check” and thenpress ENTER.2 Use ui to select the item you want to check, thenpress ENTER or p.Measurement results for each speaker are displayed.Speaker Config CheckDistance CheckChannel Level CheckCrossover CheckEQ CheckRestoreAUTO SETUPPARAMETER CHECKShow speaker configuration resultSpeaker Config. CheckDistance CheckChannel Level CheckCrossover CheckEQ CheckCheck the speaker configuration.Check the distance.Check the channel level.Check the crossover frequency.Check the equalizer.• If “EQ Check” is selected in step 2, press ui to select equalizingcurve (“Audyssey” or “Audyssey Flat”) to be checked.Use o p to switch the display between the different speakers.3 Press RETURN.The confirmation screen reappears. Repeat step 2.Retrieving Audyssey Auto Setup settingsIf you set “Restore” to “Yes”, you can return to Audyssey Auto Setupmeasurement result (value calculated at the start by MultEQ®) evenwhen you have changed each setting manually.Error messagesAn error message is displayed if Audyssey® Auto Setup could not be completed due to speaker placement, the measurement environment, etc.If this happens, check the relevant items, be sure to take the necessary measures, then perform Audyssey Auto Setup over again.NOTEBe sure to turn off the power before checking speaker connections.Examples Error details MeasuresCaution!No microphone or SpeakerRetryCheck cause of problem!AUTO SETUPAUDYSSEY AUTO SETUP MultEQRETURN Cancel• The connected setup microphone is broken,or a device other than the supplied setupmicrophone is connected.• Not all speakers could be detected.• The front L speaker was not properlydetected.• Connect the included setup microphone tothe SETUP MIC jack of this unit.• Check the speaker connections.Caution!Ambient noise is too highor Level is too lowRetryCheck cause of problem!AUTO SETUPAUDYSSEY AUTO SETUP MultEQRETURN Cancel• There is too much noise in the room foraccurate measurements to be made.• Speaker or subwoofer sound is too low foraccurate measurements to be made.• Either turn off any device generating noise ormove it away.• Perform again when the surroundings arequieter.• Check the speaker installation and thedirection in which the speakers are facing.• Adjust the subwoofer’s volume.Caution!Check cause of problem!RetryFront R NoneAUTO SETUPAUDYSSEY AUTO SETUP MultEQRETURN Cancel• The displayed speaker could not be detected. • Check the connections of the displayedspeaker.Caution!Check cause of problem!RetrySkipFront L PhaseAUTO SETUPAUDYSSEY AUTO SETUP MultEQRETURN Cancel• The displayed is connected with the polaritiesreversed.• Check the polarities of the displayed speaker.• For some speakers, this error message maybe displayed even if the speaker is properlyconnected. If you are sure the connection iscorrect, press ui to select “Skip”, thenpress ENTER.Remote control operationbuttonsMove the cursor(Up/Down/Left/Right) Confirm the setting Return to previous menu