Denon AVR-2311 Owner's Manual

Also see for AVR-2311: Service manual Service manual Owner's manual

Contents

65ENGLISH Basic versionSimple version InformationAdvanced versionSetting items Setting detailsGUI(Continued)USB : Set the USB screen display time when the input source is “USB/iPod”.• Always : Show display continuously.• 30sec : Show display for 30 seconds after operation.• 10sec : Show display for 10 seconds after operation.• OFF : Turn display off.iPod : Set the iPod screen display time when the input source is “DOCK”or “USB/iPod”.• Always : Show display continuously.• 30sec : Show display for 30 seconds after operation.• 10sec : Show display for 10 seconds after operation.• OFF : Turn display off.TUNER : Set the tuner screen display time when the input source is“TUNER”.• Always : Show display continuously.• 30sec : Show display for 30 seconds after operation.• 10sec : Show display for 10 seconds after operation.• OFF : Turn display off.Remote Preset CodesSearch a preset code toregister in the remotecontrol unit.See “Registering preset codes” (vpage 67).Quick Select NameChange the “Quick Select”display title to one you prefer.• Up to 16 characters can be input.• For character input, see page 46.Zone RenameChange the display title ofeach zone to one you prefer.• Up to 10 characters can be input.• For character input, see page 46.Trigger OutSelect the condition foractivating Trigger Out forthe input source, surroundmode, etc.See “TRIGGER OUT jacks”(vpage 20) for moreinformation on trigger out.Trigger Outn When setting for zone (MAIN ZONE / ZONE2)Trigger out is activated through linkage to the power of the zone setto “ON”.n When setting for input sourceActivate trigger out when the input source set to “ON” is selected.Active for the zone set to “ON” with “When Setting for Zone”.n When setting for surround modeActivate trigger out when the surround mode set to “ON” is selected.Active when the “MAIN ZONE” set to “ON” with “When Settingfor Zone” is selected, and when the input source set to “ON” with“When Setting for Input Source” is selected.• ON : Activate trigger on this mode.• – – – : Do not activate trigger on this mode.Setting items Setting detailsTrigger Out(Continued)Default : The “Trigger Out” settings are returned to the default settings.• Yes : Reset to the defaults.• No : Do not reset to the defaults.Remote ID SetupUsed when receivingmaintenance from a DENONservice engineer or custominstaller.1 / 2 / 3 / 4NOTEOnly use this function if so instructed by a DENON serviceperson or installer.DimmerAdjust the displaybrightness of this unit.Bright : Normal display brightness.Dim : Reduced display brightness.Dark : Very low display brightness.OFF : Turns the display off.Buttons on the main unit can be used foroperations.Each time DIMMER is pressed, the setting ischanged as shown below.Bright DimDarkOFFSetup LockProtect settings frominadvertent change.ON : Turn protection on.OFF : Turn protection off.When canceling the setting, set “Setup Lock” to “OFF”.NOTEWhen “Setup Lock” is set to “ON”, the settings listed below can nolonger be changed. Also, “SETUP LOCKED!” is displayed if you attemptto operate related settings.· Menu operations · Channel Level· RESTORER · MultEQ®· Dynamic Volume® · Dynamic EQ®Manual SetupRemote control operationbuttonsMove the cursor(Up/Down/Left/Right) Confirm the setting Return to previous menu