Denon AVR-2311CI Owner's Manual
Also see for AVR-2311CI: Service manualService manualOwner's manualOwner's manualSpecifications
                                                                                               | |
Contents
|
10ENGLISHParameter CheckThis function enables you to check the measurement results andequalizer characteristics after Audyssey Auto Setup.1 ( ui ! & ENTER2 ( ui ! ' &$ ENTERpMeasurement results for each speaker are displayed. /1 / - ;<- < . !*+, +*!* ! ? @' /1 / -Speaker Config. CheckDistance CheckChannel Level CheckCrossover CheckEQ CheckCheck the speaker configuration.Check the distance.Check the channel level.Check the crossover frequency.Check the equalizer.• If “EQ Check” is selected in step 2, press ui to select equalizingcurve (“Audyssey” or “Audyssey Flat”) to be checked.Use o p to switch the display between the different speakers.3 RETURNThe confirmation screen reappears. Repeat step 2.Retrieving Audyssey Auto Setup settingsIf you set “Restore” to “Yes”, you can return to Audyssey Auto Setupmeasurement result (value calculated at the start by MultEQ®) evenwhen you have changed each setting manually.Error messagesAn error message is displayed if Audyssey® Auto Setup could not be completed due to speaker placement, the measurement environment, etc.If this happens, check the relevant items, be sure to take the necessary measures, then perform Audyssey Auto Setup over again.NOTEBe sure to turn off the power before checking speaker connections.Examples Error details Measures / A# / !" &- A*+, +*+) ) *+, + - .! +!# -• The connected setup microphone is broken,or a device other than the supplied setupmicrophone is connected.• Not all speakers could be detected.• The front L speaker was not properlydetected.• Connect the included setup microphone tothe SETUP MIC jack of this unit.• Check the speaker connections. / A* &/ / / /1 ;<- / -'!" &- A*+, +*+) ) *+, + - .! +!# -• There is too much noise in the room foraccurate measurements to be made.• Speaker or subwoofer sound is too low foraccurate measurements to be made.• Either turn off any device generating noise ormove it away.• Perform again when the surroundings arequieter.• Check the speaker installation and thedirection in which the speakers are facing.• Adjust the subwoofer’s volume. / A &- A!"% ! # *+, +*+) ) *+, + - .! +!# -• The displayed speaker could not be detected. • Check the connections of the displayedspeaker. / A &- A!" /% ; *+, +*+) ) *+, + - .! +!# -• The displayed is connected with the polaritiesreversed.• Check the polarities of the displayed speaker.• For some speakers, this error message maybe displayed even if the speaker is properlyconnected. If you are sure the connection iscorrect, press ui to select “Skip”, thenpress ENTER.Remote control operationbuttonsMove the cursor(Up/Down/Left/Right) Confirm the setting Return to previous menu |
Related manuals for Denon AVR-2311CI
Denon AVR-2312CI Owner's Manual
Denon AVR-2310CI Owner's Manual
Denon AVR-2313CI Owner's Manual
Denon AVR-2310CI Owner's Manual
Denon AVR-2309 Owner's Manual
Denon AVR-2112CI Owner's Manual
Denon AVR-2112CI Owner's Manual
Denon AVR-2808 Owner's Manual
Denon AVR-2113 Owner's Manual
Denon AVR-2808 Owner's Manual
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine