223. Remote ID Setup mode3.1. SpecificationsWhen using multiple DENON AV receivers in the same room, make this setting so that only the desired AV receiveroperates.2.2. Setting the AV receiversStarting up:Press and hold both "STATUS" and "PRESET 1" buttons for over 3 second with the power turned on.(1) When Remote ID Setup mode is started, the following is displayed.UpperLower R E M O T E I D ?(2) Press the "QUICK SELECT 1 - 4" button that corresponds to the number you want to set.Button FL DisplayQUICK SELECT 1 R E M O T E I D 1QUICK SELECT 2 R E M O T E I D 2QUICK SELECT 3 R E M O T E I D 3QUICK SELECT 4 R E M O T E I D 4(3) Turn off the power using "ON/STANDBY" button.(4) Turn on the power using "ON/STANDBY" button.b When Remote ID Setup mode is running, operations other than the "QUICK SELECT 1 - 4" buttons or "ON/STANDBY" buttons on the main unit are not received.2.2. Setting the Remote control unit(1) Press and hold both "ZONE/DEVICE (1)" button for at least 3 second.The zone mode indicator flashes twice.(2) Press the "AMP" button.The zone mode indicator flashes twice.(3) Press the "1, 2, 3 or 4" button.The zone mode indicator flashes twice.NOTE:If the IDs do not match, "AVAMPz" (z is the main unit's remote control ID) appears on the display when the remotecontrol unit is operated.