7DISASSEMBLY• Disassemble in order of the arrow in the following figure.• In the case of the re-assembling, assemble it in order of the reverse of the following flow.• In the case of the re-assembling, observe "attention of assembling".• If wire bundles are untied or moved to perform adjustment or replace parts etc., be sure to rearrange them neatly asthey were originally bundled or placed afterward.Otherwise, incorrect arrangement can be a cause of noise generation.FRONT PANEL ASSYRefer to "DISASSEMBLY1. FRONT PANEL ASSY"and "EXPLODED VIEW"PCB V.AUX_VOL(Ref. No. of EXPLODED VIEW : C1)PCB HP(Ref. No. of EXPLODED VIEW : C2)PCB USB(Ref. No. of EXPLODED VIEW : C3)PCB FRONT(Ref. No. of EXPLODED VIEW : C4)PCB SELECTOR(Ref. No. of EXPLODED VIEW : C5)PCB HDMI FFC GUIDE(Ref. No. of EXPLODED VIEW : C6)PCB FRONT HDMI(Ref. No. of EXPLODED VIEW : C25)POWER TRANSRefer to "DISASSEMBLY4. POWER TRANS"and "EXPLODED VIEW"POWER TRANS(Ref. No. of EXPLODED VIEW : C23)CABINET TOPHEAT SINK ASSYRefer to "DISASSEMBLY2. HEAT SINK ASSY"and "EXPLODED VIEW"PCB GUIDE R(Ref. No. of EXPLODED VIEW : C7)PCB GUIDE L(Ref. No. of EXPLODED VIEW : C8)PCB GUIDE TOP(Ref. No. of EXPLODED VIEW : C9)PCB 7CH_AMP ASSY(Ref. No. of EXPLODED VIEW : C10)HDMI UNIT ASSYRefer to "DISASSEMBLY3. HDMI UNIT ASSY"and "EXPLODED VIEW"PCB FRONT CNT(Ref. No. of EXPLODED VIEW : C11)PCB SIDE CNT(Ref. No. of EXPLODED VIEW : C12)PCB RS232C(Ref. No. of EXPLODED VIEW : C13)PCB SPK_PREOUT(Ref. No. of EXPLODED VIEW : C14)PCB RS232C CNT(Ref. No. of EXPLODED VIEW : C15)PCB FUSE(Ref. No. of EXPLODED VIEW : C16)PCB F_WIDE(Ref. No. of EXPLODED VIEW : C17)PCB INPUT(Ref. No. of EXPLODED VIEW : C18)PCB VIDEO ASSY(Ref. No. of EXPLODED VIEW : C20)PCB HDMI(Ref. No. of EXPLODED VIEW : C22)