716. DM860A Reboot mode6.1. Specifications• When DM860A is hung up, DM860A is restarted.Even when Network standby is set (Setup Menu - Network - Network - Always ON), DM860A can be reset.6.2. Operation1. Turn on MAIN ZONE button, and select NETWORK for the input source.2. Press and hold the "DIMMER" and "INFO" buttons for 3 seconds and longer.3. DM860A is restarted and returns to the normal display.FL display while DM860A is being restartedUpper N e t w o r k R e s t a r tLowerNOTE:The same operation cannot be accepted for one minute after the last 860 Reboot.7. Remote ID Setup mode7.1. SpecificationsWhen using multiple DENON AV receivers in the same room, make this setting so that only the desired AV receiveroperates.7.2. Setting the AV receiversStarting up:Turn on the power, then press and hold down the "STATUS" and "DIMMER" buttons for over 3 seconds.(1) When Remote ID Setup mode is started, the following is displayed.UpperLower R E M O T E I D ?(2) Press the "QUICK SELECT 1 - 4" button that corresponds to the number you want to set.Button FL DisplayQUICK SELECT 1 R E M O T E I D 1QUICK SELECT 2 R E M O T E I D 2QUICK SELECT 3 R E M O T E I D 3QUICK SELECT 4 R E M O T E I D 4(3) Turn off the power using "Power operation (X)" button.(4) Turn on the power using "Power operation (X)" button.b When Remote ID Setup mode is running, operations other than the "QUICK SELECT 1 - 4" buttons or "Poweroperation (X)" buttons on the main unit are not received.b Remote ID can also be set at Setup Menu - General - Remote ID.