o Cannot connect by Wi-FiSymptom Cause / Solution PageCannot connect to thenetwork.0 The network name and password (WEP, etc.) settings are wrong. Configure the network settingsaccording to the setting details of this unit.970 Reduce the distance between the wireless LAN access point and this unit, remove any obstructions andmake sure the view to the access point is unobstructed before trying to connect again. Also, installmicrowave ovens and other network access points as far away as possible.-0 Check the router power supply. -0 This unit supports IEEE802.11.b/g/n. -0 Configure the access point channel settings away from channels that are being used by other networks. -0 This unit is not compatible with WEP (TSN). -Cannot connect to WPS. 0 Check that the WPS mode of the router is operating. -0 Press and hold the Wi-Fi CONNECT/WPS button on this unit for approx. 3 seconds within 2 minutes ofoperating the router.-0 A router/settings that are compatible with WPS 2.0 standards are required. Set the encryption time to“None”, “WPA-PSK (AES)” or “WPA2-PSK (AES)”.920 If the router encryption method is WEP/WPA-TKIP/WPA2-TKIP, you cannot connect by using the Wi-FiCONNECT/WPS button. In this case, use the “Auto-Scan” or “Manual” method to connect.97Cannot connect to thenetwork using iPhone/iPodtouch/iPad.0 Update the iPhone/iPod touch/iPad firmware to the latest version. -0 When using a USB cable to configure the settings, the iOS device firmware version needs to support iOS5 or later. When configuring the settings via a wireless connection, iOS 7 or later needs to be supported.-Contents Connections Playback Settings Tips Appendix112Front/Toppanel Rear panel Remote control unit Index