NetworkTo use this unit by connecting it to a home network (LAN), you must configure network settings. If you set up your home network via DHCP, set “DHCP” toOn (use the default setting). This allows this unit to use your home network.If you assign an IP address for each device, you must use the “IP Address” setting to assign an IP address to this unit and enter the information about yourhome network such as the gateway address and subnet mask.Network InformationDisplay network information.Friendly Name / DHCPOn or Off / IP Address / MAC Address / SSIDzz This is displayed only while a Wi-Fi connection is enabled.Network ControlEnables network communication in standby power mode.On:The network function can be used when in standby powermode. Main unit operable with a network compatiblecontroller.Off (Default): The network function cannot be used in standby powermode.When using the Web control function or a network controller or when you want to useBluetooth/NFC quickly when the power is off, set “Network Control” to “On”.NOTEWhen “Network Control” is set to “On”, the unit consumes more standby power.Contents Connections Playback Settings Tips Appendix91Front/Toppanel Rear panel Remote control unit Index