Operation13ENGLISHENGLISHUsing the timer play functionAlso refer to the operating instructions of the timer device.DCD-700AE (This unit)AmplifierTimer deviceAC outletTurn on the power of the connected components.Switch the amplifier’s input function to the functionto which the player is connected.12Load a disc in the player.3Set the audio timer for the desired times.4 Turn the timer “ON”.• The power of the components connected to the timer turnsoff.When the set time is reached, the power of the differentcomponents automatically turns on and playback starts from thefirst track.5If a problem should arise, first check the following:1. Are the connections correct ?2. Have you operated the player according to the Operating Instructions ?If this unit is not operating properly, check the items listed in the table below. Should the problem persist, there may be a malfunction.Disconnect the power immediately and contact your store of purchase.PageMeasuresCauseSymptomDisc tray does not open. • The power is not on. • Turn on the power. 7“NO DISC” is displayed even thougha disc is loaded.• The disc is not properly loaded. • Reload the disc. 2, 3“00 Tr 00 : 00” is displayed eventhough a disc is loaded.• The loaded disc is not a CD. • Load a CD. 2Disc is not played when play buttonis pressed.• The disc is dirty or scratched. • Wipe the dirt off the disc or replace the disc. 3No sound is produced or sound isdistorted.• The output cables are not properly connected to theamplifier.• The amplifier’s function setting or adjustments arenot right.• Check the connections.• Check the amplifier’s function and controls andadjust as necessary.6–No digital signals are output. • The pure direct mode is set to “MODE 2”.• The connection cables are not properly connected.• The pitch control play mode is set.• Change the pure direct mode setting.• Check the connections.• Set back to the normal playing speed.469Specific section of the disc cannot beplayed properly.• The disc is dirty or scratched. • Wipe the dirt off the disc or replace the disc. 3Programmed playback is not possible. • The tracks have not been programmed properly.• Programmed playback is not possible with MP3 andWMA files.• Program properly.• Use a CD.88A CD-R or CD-RW disc cannot beplayed.• The disc has not been finalized.• The recording conditions are bad or the quality of thedisc itself it poor.• Finalize the disc then play it.• Use a properly recorded disc.22Set does not operate properly whenremote control unit is operated.• The batteries are spent.• The remote control unit is too far from the set.• Replace the batteries with new ones.• Move the remote control unit closer to the set.33“Not Support” is displayed whenplaying riles recorded in MP3 orWMA format.• You have selected a copyright-protected WMA fileor a file that cannot be played normally.• Use the 8 or 9 button to select a different file. 11, 12TroubleshootingOthers