Getting Started Getting Started2ENGLISHENGLISHAccessoriesCheck that the following parts are attached in addition to the mainunit:q Operating instructions .............................................................1w Service station list....................................................................1e Remote control unit (RC-1032) ................................................1r R03/AAA batteries ...................................................................2t Pin-plug cable (Cable length: Approx. 1.0 m)...........................1r teBefore using• Handle the power supply cord carefully.Do not damage or deform the power supply cord. If it is damaged ordeformed, it may cause electric shock or malfunction when used.When disconnecting the power supply cord from the wall outlet,hold the plug and do not pull on the cable.• Do not open the top cover.In order to prevent electric shock, do not open the top cover.If problems occur, contact your DENON dealer.• Do not place anything inside.Prevent metal objects from entering the CD player and avoid spillingliquids on it.Electric shock or malfunction may result.• Cautions on moving.First, if a disc is loaded, eject it, then turn off the power, unplug thepower supply cord from the power outlet and disconnect theconnection cables with other devices.• Cautions on using mobile phones.Using a mobile phone near this unit may result in noise. If so, movethe mobile phone away from this unit when it is in use.• Store these instructions in a safe place.After reading, store this instructions along with the warranty card ina safe place.• Note that the illustrations in these instructions may differ fromthe actual unit for explanation purposes.About discsNOTE:• This CD player uses a semiconductor laser. To ensure stableoperation, it is recommended to use the set indoors at atemperature of 5°C (41°F) ~ 35°C (95°F).Discs usable on this setq Music CDsDiscs with the mark at the right can be used onthis set.Note however that discs with special shapes(heart-shaped discs, octagonal discs, etc.) cannotbe played. Do not attempt to play them, as doingso could damage the set.w CD-R/CD-RW• Some discs and some recording formats may not be playable.• Non-finalized discs cannot be played.Finalization:Finalization is the process that makes recorded CD-R/CD-RW discsplayable on compatible players.Holding discsDo not touch the signal surface.Loading discs• Set the disc with the labeled side facing up.• Make sure the disc tray is fully open when inserting the disc.• Place the discs flatly, 12 cm discs in the outer tray guide (Figure 1),8 cm discs in the inner tray guide (Figure 2).Figure 1Outer tray guide12 cm discsFigure 2Inner tray guide8 cm discs• Place 8 cm discs in the inner tray guide without using an adapter.• “00 Tr 00 : 00” is displayed if a disc that cannot be played isinserted.• “NO DISC” is displayed if a disc is loaded upside down or if no discis loaded.