Denon DVD-2910 Operating Instructions Manual

Also see for DVD-2910: Operating instructions Specifications Supplementary guide Operating instructions Service manual

7ENGLISH(2) Connecting to a TV or Monitor Equipped with Color Component InputConnectorsCOMPONENT VIDEO INPR/CRPB/CBYAUDIO INL RColor component output connectors (PR /CR , PB/C B and Y)The red (P R /C R ), blue (P B /C B ) and brightness (Y) signals are output independently,achieving more faithful reproduction of the colors.• The color component input connectors may be marked differently on some TVs ormonitors (PR , PB and Y/R-Y, B-Y and Y/C R , CB and Y, etc.). For details, refer to the TV’soperating instructions.• Connect in this way if your TV is compatible with Progressive Scan.DVD-2910To power outletNOTES:• Use the three commercially available video cords to connect the DVD-2910’s color component outputconnectors to the TV or monitor.• Set the “TV TYPE” in “VIDEO SETUP” in “SETUP” to comply with your TV’s video format. When the TVis PAL formated, set to PAL. (See page 18.)• Set the “VIDEO OUT” in “VIDEO SETUP” in “SETUP” to comply with Progressive TV.• To use with 5.1ch audio output, set “2CH (SRS OFF)” or “2CH (SRS ON) ” in “AUDIO CHANNEL” in“AUDIO SETUP” in “SETUP” at the initial settings. (See page 19.)• Set the “TV ASPECT” in “VIDEO SETUP” in “SETUP” to comply with your TV’s aspect. (See page 18.)TVCONSUMERS SHOULD NOTE THAT NOT ALL HIGH DEFINITION TELEVISION SETS ARE FULLY COMPATIBLEWITH THIS PRODUCT AND MAY CAUSE ARTIFACTS TO BE DISPLAYED IN THE PICTURE. IN CASE OF525 OR 625 PROGRESSIVE SCAN PICTURE PROBLEMS, IT IS RECOMMENDED THAT THE USERSWITCH THE CONNECTION TO THE “STANDARD DEFINITION” OUTPUT.(3) Connecting to a TV with 21-pin SCART Terminal (For only European model)• Use the commercially 21-pin SCART cable to connect the TV’s 21-pin SCART terminal to the DVD-2910’s 21-pin SCART terminal (AV1).DVD-2910To power outletTV21-pin SCART terminal• Set the “TV TYPE” in “VIDEO SETUP” in“SETUP” to comply with your TV’s video format.When the TV is PAL formated, set to PAL. (Seepage 18.)NOTES:• Some discs contain copy prohibit signals. If suchdiscs are played via a VCR, the copy prohibitsystem may cause disturbance in the picture.• To improve picture quality, you can change the video signal output from the AV1 terminal from “Video” toeither “S-Video” or “RGB” to suit the type of television you are using (See page 18.).