Denon DVD-2910 Operating Instructions Manual

Also see for DVD-2910: Operating instructions Specifications Supplementary guide Operating instructions Service manual

9ENGLISH(6) Connecting to a Digital Recorder (MD Recorder, DAT Deck, etc.)8 9B✽ Set the “AUDIO SETUP” default setting as shown below. (See page 19.)• “DIGITAL OUT” → “PCM”“LPCM (44.1 kHz / 48 kHz)” → “ON”Playing DVDs with incorrect settings may result noise that could damage your ears or the speakers.DVD-291075 Ω/ohms pin-plug cable (commercially available)Optical fiber cable (commercially available)Digital audioinputconnector(COAXIAL)Digital audio inputconnector (OPTICAL)(7) Connecting to a Stereo ComponentDVD-2910 Stereo componentNOTE:• When connecting to a 2-channel audio stereo device using the 5.1ch AUDIO OUT, set “AUDIOCHANNEL” under “AUDIO SETUP” on the “SETUP” to “2CH (SRS OFF) ” or “2CH (SRS ON) ” (Seepage 19.). For multi-channel sources, the signals are down-mixed into two channels (analog).(Only the front left and right channels are output for sources for which down-mixing is prohibited.)(5) Connecting a basic 5.1-channel surround systemAnalog 5.1-channel audio signals can be output from the DVD-2910.The multichannel audio signals recorded in packed PCM and the multichannel Super audio CDs can be playedwhen an AV amplifier equipped with analog 5.1-channel audio inputs is connected.DVD-2910To power outletFront speaker (left)Center speakerFront speaker (right)SubwooferSurround speaker (right)AV amplifier with 5.1-channelinput terminalsSurround speaker (left)FRONTSUBWOOFERSURROUNDCENTERNOTES:• For multi-channel connections, set “AUDIO CHANNEL” under “AUDIO SETUP” at “SETUP” to “MULTICHANNEL” and make the “SPEAKER CONFIGURATION”, “CHANNEL LEVEL” and “DELAY TIME” settings.(See pages 19, 20.)• With the DVD-2910, we recommend turning the digital output off by using the PURE DIRECT MODE andonly outputting analog signals in order to keep interference from the digital output circuitry to the minimumand allow you to enjoy high bit, high sampling frequency, high quality multi-channel sound. (See page 24.)NOTE:• Digital audio signals cannot be output when playing Super Audio CDs. Use analog connections to recordSuper Audio CDs.(or)