0ENGLISHGetting Started Setup Playback Setting the Timer Other Functions Troubleshooting SpecificationsRecord Player(/%"6%*0065RL• With some record players, noise may be generated when the groundwire is connected. If so, disconnect the ground wire.• Set the CARTRIDGE selection switch to “jMM” or “hMC”according to the cartridge being used.NOTEThe RCD-CX1’s SIGNAL GND terminal is meant to reduce noise whena record player is connected. This is not a safety ground terminal.iPod®• When using a control dock for iPod, the Control Dock for iPod mustbe set. For details, refer to the operating instructions of the ControlDock for iPod.• When the control dock for iPod is connected, the function indicatorswitches from “LINE1” to “iPod”.• To use an iPod, see “iPod® Playback” (vpage 22).Use a DENON control dock for iPod (ASD-1R or ASD-3N/3W, soldseparately) to connect the iPod to the RCD-CX1."4%/8R LR LiPodConnectionsRLRL3-*/Connecting the PlaybackComponentsTurntableConnecting a Power Amp andSubwooferUse when adding a power amp, subwoofer, etc.Power amp /SubwooferNOTEDO NOT insert a short pin plug for recording output (REC) and pre-outterminals, as this may result in damage.