Denon RCD-CX1 Owner's Manual

Also see for RCD-CX1: Owner's manual Specifications Service manual

Getting Started Connections Setup Playback Setting the Timer Other FunctionsENGLISHSpecificationsIf a problem should arise, first check the following:1. Are the connections correct?2. Is the set being operated as described in the owner’s manual?3. Are the other components operating properly?If this unit does not operate properly, check the items listed in the table below. Should the problem persist,there may be a malfunction.In this case, disconnect the power immediately and contact your store of purchase.Symptom Cause Countermeasure PageSet does notoperate properly.• External noise or interference iscausing the set to malfunction.• Reset the microprocessor. 27When the poweris turned on, thepower indicatordoes not lightand no sound isproduced.• Connection of the power cord isfaulty.• Check that the power plugs aresecurely inserted into the RCD-CX1’s AC inlet and the wall poweroutlet.12The powerindicator lightsbut no sound isproduced.• The speaker cables are notproperly connected.• The function (input) is incorrect.• The volume is set too low.• Connect securely.• Switch to the correct function(input).• Adjust the volume to anappropriate level.91515No sound isproduced fromone side.• The speaker cables are notproperly connected.• The input cables are not properlyconnected.• The left/right balance is off.• Connect securely.• Connect securely.• Adjust the left/right balance.910, 1115For stereosources, thepositions of theinstruments areinverted.• The connections of the speakercables or input cables areinverted.• Check and remedy theconnections.9 ~ 12GGeneralHSymptom Cause Countermeasure PageSet does not workproperly whenremote controlunit operated.• Batteries are worn.• You are operating outside of thespecified range.• Obstacle between main unit andremote control unit.• The batteries are not inserted inthe proper direction, as indicatedby the polarity marks in thebattery compartment.• The set’s remote control sensoris exposed to strong light (directsunlight, inverter type fluorescentbulb light, etc.).• Replace with new batteries.• Operate within the specifiedrange.• Remove the obstacle.• Insert the batteries in theproper direction, following thepolarity marks in the batterycompartment.• Move the set to a place in whichthe remote control sensor willnot be exposed to strong light.44444GRemote Control UnitHTroubleshootingTroubleshooting