Getting StartedConnectionsSetupPlaybackSetting the TimerTroubleshootingENGLISHSpecificationsLast Function MemoryThis stores the settings as they were directly before the standbymode was set.When the power is turned back on, the settings are restored to asthey were directly before the standby mode was set.Resetting the MicroprocessorPerform this procedure if the display is abnormal or if operationscannot be performed.When the microprocessor is reset, all the settings are reset totheir default values.1Unplug the power cord.2Plug the power cord into a power outlet while pressing<+/9>andsimultaneously.3After about 15 seconds “RESET” is displayed toindicate that the microprocessor has been reset.If “RESET” is not displayed in step 3, start over from step 1.Convenient FunctionsAuto Power OnWhen the power is in standby, the power turns on when any ofthe buttons below other thanON/STANDBYis operated, and therespective operation is performed.•<2/5>··············The disc tray opens.•1/3for the different functions························Playback of that source starts.•[TUNER]············Playback of the tuner starts.•[2]···················Change the function to “CD” and switch thepower on.•[PHONO]···········Change the function to “PHONO” and switchthe power on.•[LINE1/LINE2]····Change the function to the finally set “LINE”and switch the power on.NOTEWhentheiPodcanbeplayed,press[iPod1/3]tostartiPodplayback.Auto Function Selector FunctionWhen one of the buttons below is pressed, the function switchesto the respective function and playback of that source starts.•1/3·················The function switches to “CD” and the CDstarts playing.•[2]···················The function switches to “CD” and the stop.•[iPod1/3]········The function switches to “iPod” and the iPodstarts playing.•[TUNER]············The functions switches to “TUNER” and theband last set is tuned in.Other FunctionsOther Functions