ENGLISH26<1/3><5>ON/STANDBY<8/–>ON/STANDBY[uiop][CD1/3][TUNER][USB/iPod1/3][DOCK1/3][MENU][SLEEP][ENTER/MEMO]Button located on both the main unit and the remote controlBUTTONButton only on the main unitButton only on the remote control[BUTTON]Symbols used to indicate buttons in this manualOther functionsUsing an optimizing fi lterAn optimizing filter suited for the properties of the speakers (SC-M37)can be used.1Press[MENU].2Use[ui]to select “SPK OPTIMISE”, then pressthe[ENTER/MEMO]or[p].3Use[ui]to select “ON”, then press the[ENTER/MEMO]or[p].The setting is entered.ONThe response is optimized for the speakers (SC-M37, soldseparately).OFFThe response is flat.Auto power onWhen the power is in standby, the power turns on when any ofthe buttons below other thanON/STANDBYis operated, and therespective operation is performed.•<5>...............................................The disc tray opens.•<1/3>for the different source ....Playback of that source starts.•[TUNER]........................................Playback of the tuner starts.NOTEThe Auto Power On function cannot be used with control dock foriPod.Auto source selector functionWhen one of the buttons below is pressed, it switches to that sourceand starts playback on that source.•[CD1/3]...................The source switches to “DISC” and the discstarts playing.•[USB/iPod1/3]........The source switches to “USB” and the USBstarts playing.•[DOCK1/3]..............The source switches to “AUX1/Dock” and theiPod starts playing.•[TUNER].....................The source switches to “TUNER” and theband last set is tuned in.Auto standbyWith the Auto standby ON, this unit will automatically enter thestandby mode after about 30 continuous minutes of stop mode withno operation.1Press[MENU].2Use[ui]to select “AUTO STANDBY”, then press[ENTER/MEMO]or[p].3Use[ui]toselect“ON”,thenpress[ENTER/MEMO]or[p].The setting is entered.NOTEIn the following situations, the Auto standby function does not operate.• When an iPod or USB memory device is connected to the USB porton the unit.• When the source is “TUNER”“AUX1” or “AUX2”.• When the source is “AUX1/Dock”, and an iPod is connected tocontrol dock for iPod. (ASD-11R only)• When the source is “PORTABLE IN” and a device is connected tothe portable jack.Last function memoryThis stores the settings as they were immediately before going intothe standby mode.When the power is turned back on, the settings are restored to asthey were immediately before going into the standby mode.Resetting the microprocessorPerform this procedure if the display is abnormal or if operationscannot be performed.When the microprocessor is reset, all the settings are reset to theirdefault values.1Unplug the power cord.2Plug the power cord into a power outlet while pressing<8/–>andsimultaneously.• “INITIALIZE” is displayed.If “INITIALIZE” does not display in step 2, start over from step 1.
