Denon S-5BD Owner's Manual

Also see for S-5BD: Product sheet Code List Service manual

Contents

ENGLISHSimpleVersionRemoteControlPlayback(Advanced)Connections Playback(Basic)Multi-zone GUISettingsGettingStarted TroubleshootingOtherInformation Spec. IndexPartNamesSet Up Speakers (Audyssey™ Auto Setup)STEP 4CalculationSTEP 5CheckSTEP 6Store9 On the STEP3 screen, select “Next→ Calculation”, and then pressENTER.Measuring results are analyzed, and thefrequency response of each speaker in thelistening room is determined.FIRST SETUP 2/21 2 3 4 5 6STEP4 Calculation20%Now calculating... Please wait.Analysis takes several minutes to complete. Thetime required for this analysis depends on thenumber of speakers connected.The more connected speakers there are, thelonger it takes to perform analysis.•10 Select the item you want to check,and then press ENTER.FIRST SETUP 2/21 2 3 4 5 6Ch. Level CheckRETURNNext StoreCrossover CheckSpkr Config CheckDistance CheckSTEP5 CheckCheck processing results.To proceed, press “Next”.Select item to checkEnter CancelSubwoofers may measure a greater reporteddistance than the actual distance due to addedelectrical delay common in subwoofers.If you want to check another item, pressRETURN.••11 Select “Next → Store” and then pressENTER.12 Press ENTER.Save the measuring results.FIRST SETUP 2/21 2 3 4 5 6RETURNStoreSTEP6 StorePress “Store” to store calculation results.Apply and store measurement resultEnter CancelThe save operation takes about 30 seconds tocomplete.NOTEDuring saving of measuring results, be sure not toturn off the power.•13 When the following screen isdisplayed, unplug the setupmicrophone from the unit’s SETUPMIC jack.FIRST SETUP 2/21 2 3 4 5 6NoYesFinishStoring complete.Auto Setup is now finished.Please unplug microphone.Turn on Dynamic Volume?Do not use "Dynamic Volume".Enter14 Set Dynamic Volume.FIRST SETUP 2/21 2 3 4 5 6NoYesFinishStoring complete.Auto Setup is now finished.Please unplug microphone.Turn on Dynamic Volume?Use "Dynamic Volume".EnterFor details of Dynamic Volume settings, seepage 52.•When turning Dynamic Volume onSelect “Yes”, and then press ENTER.This completes speaker setup.When turning Dynamic Volume offSelect “No”, and then press ENTER.The MultEQ default settings are displayed.Press ENTER to exit.n•n••CD MultEQ : OFFBD/DVDFM/AMHDMI1/2/3USBAUX1/2MultEQ : ONMultEQ : OFFMultEQ : ONMultEQ : OFFMultEQ : ONShows information about current settingsExitFIRST SETUP 2/2For details of MultEQ settings, see page 51.•NOTEAfter performing Audyssey Auto Setup, do notchange the speaker connections or subwoofervolume. In event of a change, perform AudysseyAuto Setup again.Remote control operationbuttonsMove the cursor(Up/Down/Left/Right) Confirm the setting Return to previous menu