Denon S-5BD Owner's Manual

Also see for S-5BD: Product sheet Code List Service manual

Contents

ENGLISHRemoteControlPlayback(Advanced)ConnectionsSimpleVersionPlayback(Basic)Multi-zone GUISettingsGettingStarted TroubleshootingOtherInformation Spec. IndexPartNames1 Connect the setup microphone.The following screen is displayed.1 2 3 4 5 6Speaker AssignRETURNAuto Setup StartSTEP1 PreparationIn a typical setup, select "Auto Setup Start". Whenconnecting speakers in a setup other than 2ch/2.1ch/5.1ch,select "Speaker Assign".Start Auto SetupEnter CancelAUDYSSEY AUTO SETUP2 Select “Speaker Assign” and thenpress ENTER.1 2 3 4 5 6Speaker AssignRETURNAuto Setup StartSTEP1 PreparationIIn a typical setup, select "Auto Setup Start". When connectingspeakers in a setup other than 2ch/2.1ch/5.1ch, select"Speaker Assign".Select speaker configurationEnter CancelAUDYSSEY AUTO SETUP3 Select the configuration of theconnected speakers, and then pressENTER.1 2 3 4 5 6Speaker AssignRETURNAuto Setup StartSTEP1 PreparationConnect the speakers and place them accordingto the recommendations in he manual.Set the following itemsif nesessary.Select speaker configurationEnterUp/Down CancelAUDYSSEY AUTO SETUP5.1CHSpeaker Assign2.0CH/2.1CH5.1CH + Surround Back5.1CH + Front HeightUse pre-out for surround backEnter CancelRETURN5.1CH Connect 5.1-channel speakers.2.0CH/2.1CH Connect the front speakers andsubwoofer only.5.1CH +Surround BackConnect the surround backspeakers to the PRE OUTconnectors.5.1CH +Front HeightConnect the front heightspeakers to the PRE OUTconnectors.4 Select “Auto Setup Start” and thenpress ENTER.Proceed to page 7“ STEP1 Preparation ” Step 4.NOTEThe “FIRST SETUP” screen is displayedonly when the power is first turned on afterpurchase.After performing Audyssey Auto Setup, do notchange the speaker connections or subwoofervolume. In event of a change, perform AudysseyAuto Setup again.••SpeakersCarefully check the left (L) andright (R) channels and + (red)and – (black) polarities on thespeakers being connected to thisunit, and be sure to interconnectthe channels and polaritiescorrectly.Connecting the speakercablesPeel off about 10 mm ofsheathing from the tip of thespeaker cable, then eithertwist the core wire tightly orterminate it.Speaker impedanceFront4 – 16 ΩCenterSurroundConnect2.1-channel ConnectionFL FRSWNOTEConnect so that the speaker cable core wires do not protrudefrom the speaker terminal. The protection circuit may beactivated if the core wires touch the rear panel or if the + and– sides touch each other (vpage 74 “Protection Circuit”).Never touch the speaker terminals while the power supply isconnected. Doing so could result in electric shock.n••Set Up SpeakersHere we describe how to set up speakers other than 5.1-channel speakers.For the method of setting up 5.1-channel speakers, see “Simple Version”, “r Set Up Speakers(Audyssey™ Auto Setup)” (vpage 6).First install and connect the speakers to this unit.Remote control operationbuttonsMove the cursor(Up/Down/Left/Right) Confirm the setting Return to previous menu