Denon S-5BD Owner's Manual

Also see for S-5BD: Product sheet Code List Service manual

Contents

ENGLISH RemoteControlPlayback(Advanced)ConnectionsSimpleVersionPlayback(Basic)Multi-zone GUISettingsGettingStarted TroubleshootingOtherInformation Spec. IndexPartNames1 Set the HDMI output connector corresponding withthe HDMI control function.On the GUI menu, set “Manual Setup” – “HDMI Setup” –“HDMI Control” (vpage 55).2 Turn the power on for all the equipment connectedby HDMI cable.3 Set the HDMI control function for all equipmentconnected by HDMI cable.Set “HDMI Control” – “Control” (vpage 55) to “ON“.Please consult the operating instructions for the connectedequipment to check the settings.Carry out steps 1 and 2 should any of the equipment beunplugged.••4 Switch the television input to the HDMI inputconnected to this unit.5 Switch the unit input to the HDMI input source andcheck if the picture from the player is ok.6 When you turn the TV’s power to standby, checkthat the power of this unit also goes to standby.If the HDMI control function does not operate properly, check thefollowing points.Is the TV compatible with the HDMI control function?Is the “HDMI Control” – “Control” (vpage 55) set to “ON”?Is the “Power Off Control” (vpage 55) set to “ON”?Are the HDMI control function settings of all equipment correct?(Step 3)••••Convenient FunctionsHDMI Control FunctionWhen you make an HDMI connection with a TV compatible withthis unit and HDMI control functions, you can perform the followingoperations by setting the HDMI control function of each device.The unit power off can be linked to the TV poweroff step.When you set “Output audio from amp” in the TV audio outputsetup operation, you can switch the amp power on.You can switch audio output devices with a TVoperation.You can adjust the unit volume in the TV volumeadjustment operation.You can switch the unit input source throughlinkage to TV input switching.When playing the player, the unit input functionswitches to the function of that player.nnnnnNOTEWhen “HDMI Control” is set to “ON”, it consumes more standbypower.The HDMI control function controls operations of a TV that iscompatible with the HDMI control function. Make sure that the TVand HDMI are connected when you perform HDMI control.Some functions may not operate depending on the connected TV.Check the owner’s manual of each device for details beforehand.When “HDMI Setup” – “HDMI Control” – “Power Off Control” onthe GUI menu is set to “OFF” (vpage 55), this unit is not set tostandby even if the connected device is in the standby mode.When connection changes are implemented, such as addingconnections to HDMI devices, linked operations may be initialized.In this case, you will need to reconfigure the settings.•••••One Touch Play FunctionWhen this unit is in standby mode and contains a disc, the followingsequence of playback operations can be performed automaticallysimply by pressing ONE TOUCH PLAY.This unit and TV turn on.This unit’s input source switches to “BD/SD”.The TV input switches to this unit’s input.Disc playback starts.Setting RequirementsTo use this function, connect this unit and the TV with an HDMIcable and turn on the HDMI control function on both devices.Set “Manual Setup” – “HDMI Setup” – “HDMI Control” (vpage55) on the GUI menu on this unit to “ON”.Press ONE TOUCH PLAY. FrontNOTEThe One touch play function will not operate if another device isconnected between this unit and the TV. Connect this unit directlyto the TV.••••n••