Desa RFN30TA Operation And Installation Manual

Also see for Comfort Glow RFN30TA: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

www.desatech.com109889-01B 5PRODUCT FEATURESSAFETY PILOTThis heater has a pilot with an Oxygen Deple-tion Sensing (ODS) safety shutoff system. TheODS/pilot is a required feature for vent-free roomheaters. The ODS/pilot shuts off the heater if thereis not enough fresh air.PIEZO IGNITION SYSTEMThis heater has a piezo ignitor. This system re-quires no matches, batteries or other sources tolight heater.THERMOSTATIC HEAT CONTROLThis heater has a thermostat sensing bulb and acontrol valve. This results in the greatest heatercomfort. This can also result in lower gas bills.ASSEMBLING HEATERTools Required:• Phillips screwdriver• 5/16” hex wrench• slotted screwdriverREMOVING FRONT PANEL OFHEATER1. Remove two screws near bottom corners offront panel with Phillips screwdriver.2. Pull bottom of front panel forward, then down(see Figure 2).INSTALLING HOOD1. Remove hood from protective tray.2. Locate 4 black sheet metal screws from hard-ware pack.3. Place hood on deflector and line up holes (seeFigure 3).4. Secure hood to deflector with 4 black sheetmetal screws.Note: Side of hood should be on the outside flangeof deflector.Figure 2 - Removing Front Panel ofHeaterLogRetainingBracketsBurnerShieldScreenFrontPanelDeflectorLogTruss-HeadScrewBrassFrontTrimScrew ScrewHeaterCabinetNutHoodSheetMetalScrewFigure 3 - Assembling Heater