Dynex DX-15L150A11 User Manual

Also see for DX-15L150A11: Quick setup guide Firmware update Quick setup guide Guía De Instalación Rápida User manual

10 Making connectionsDX-15L150A11/DX19L150A11/DX-22L150A113 Connect the other end of the component video cable to theCOMPONENT Y/Pb/Pr jacks on the back of your TV.4 Connect an audio cable to the AUDIO OUT jacks (L/R) on thecomponent device.5 Connect the other end of the audio cable to theCOMPONENT AUDIO-R and AUDIO-L jacks on the back ofyour TV.To play from the component video device:1 Turn on the TV, then press INPUT. The INPUT SOURCE menuopens.2 Press or to select Component, then press ENTER.Note: You can also press COMP to select Component.3 Turn on the component video device and start playback. Refer tothe instructions that came with the component video device.Connecting an antenna, cable TV, orsatellite TV box via coax• If you are connecting a satellite TV or cable box, you can use oneof the following (if available):• Best - HDMI cable• Better - Video component cables• Better - S-Video cable• Good - Video composite cable• Acceptable - 75-ohm coaxial cable.To connect an antenna, cable TV, or satellite TV box:• Connect one end of a 75-Ohm, coaxial cable to the RF jack on theback of the TV, then connect the other end of the cable to theantenna or cable TV wall jack.Notes:• We recommend using a 75-Ohm, coaxial cable to reduce interferenceand noise that may be caused by radio wave transmissions.• Do not bundle the coaxial cable with the power cord or any othercables.• If you are using an antenna and reception is not good, contact aservice technician to adjust the antenna.Connecting a VCRNote: If the VCR has an HDMI jack (best), component jacks (better), or anS-Video jack (good), connect the VCR using the best availableconnection.To connect a VCR:1 Make sure that your TV’s power cord is unplugged and the VCR isturned off.2 Connect one end of a standard AV cable (not included) into theAV IN 1 VIDEO jack on the back of the TV, then connect the otherend of the cable to the AV OUT VIDEO jack on the VCR.-OR-For a better picture, you can connect an S-Video cable to theS-VIDEO OUT jack on the VCR and the S-VIDEO jack on your TV.3 Connect the audio connectors of the AV cable (the red and whiteconnectors) to the AV OUT AUDIO jacks of the VCR, then connectthem to the AV IN 1 AUDIO-L and AUDIO-R jacks on the back ofyour TV.To play the VCR:1 Turn on the TV, then press INPUT. The INPUT SOURCE menuopens.2 Press or to select AV1 or S-Video, then press ENTER.Note: You can also press VIDEO once to select AV1 or three times forS-Video.3 Turn on the VCR, insert a videotape, then press PLAY on the VCR.75-Ohm coaxial cableTo wall jackBack of TVOUTINANTENNA75-Ohm coaxial cableCable box or satellite receiverBack of TVHDMIVideo or S-VideoComponentANT/CABLE INANT/CABLE INANT/CABLE INANT/CABLE INVCRAudio cableBack of TVNote: Cables are often color-coded to connectors.Connect yellow to yellow, red to red, and white to white.S-Video cableBack of TVVCRVideo cableAudio cable