18 Changing channel settingsDX-15L150A11/DX19L150A11/DX-22L150A11Changing channel settingsAutomatically scanning for channelsWhen you scan for channels, your TV searches for channels with signalsand stores the channel information in the channel list. When you pressCH or CH , your TV goes to the next or previous channel in thechannel list and skips the channels that do not have signals.If the TV signal source changes, for example if you change from anoutdoor antenna to cable TV (no box), you need to scan for channels.To auto scan for channels:1 Press MENU. The on-screen menu opens.2 Press or to highlight CHANNELS. The CHANNELS menuopens.3 Press or to highlight Auto Channel Search, then pressENTER. The Auto Channel Search screen opens.4 Press or to select Antenna or Cable, then press ENTER tostart the scan.You can see the progress of the search and the number ofchannels found in the on-screen menu. After the scan iscomplete, the menu closes and your TV tunes to the first channelon the list.Notes:You can press EXIT to stop the search at any time.If you don’t need analog channels after auto searching for digitalchannels, you can press EXIT or MENU within ten seconds of theprompt.You don't need to scan for channels if you are using a cable or satellite boxbecause the available channels are provided by the box. Press EXIT toclose the menu.5 Press MENU to return to the previous menu, or press EXIT toclose the menu.Hiding and adding channelsYou can delete channels from the channel list so that your TV skips thechannels when you press CH /CH . You can still tune to the hiddenchannel by using the number buttons. You can also add channels to thelist.To hide or add a channel:1 Press MENU. The on-screen menu opens.2 Press or to highlight CHANNELS. The CHANNELS menuopens.3 Press or to highlight Add/Skip Channels, then pressENTER or . The Channel List screen opens.4 Press , , or to highlight the channel you want to hide oradd (the default is to show the channel), then press ENTER toremove the check mark from the channel. You can also add achannel by selecting it, then pressing ENTER to place a checkmark next to it.