Dynex DX-15L150A11 User Manual

Also see for DX-15L150A11: Quick setup guide Firmware update Quick setup guide Guía De Instalación Rápida User manual

4 Installing and removing the standDX-15L150A11/DX19L150A11/DX-22L150A11Installing and removing thestandYou must install your TV into the stand in order for it to stand upright ona cabinet or other flat surface. If you intend to mount your TV on a wallor other vertical surface, you must remove the stand column.Cautions• Read these instructions carefully before you try to assemble thestand or remove the stand column.• Make sure that you handle the TV carefully when attempting toassemble or remove the stand. If you are not sure of your abilityto do this, contact a professional installer or service technician.Dynex is not responsible for any damages or injuries that occurbecause of mishandling or incorrect assembly.• Use a soft cushion or covering to prevent scratching or damage tothe TV screen or cabinet.• Before assembly or removal of the stand, unplug the power cord.Installing the standNote: Your TV may differ from the illustrations shown.To install the stand:1 Lay the TV on a flat, cushioned surface.2 Align the stand with the TV, as shown in the followingillustration.3 Carefully align and insert the base into the stand until the lockingmechanism clicks into place.Installing a wall-mount bracketWarning: These instructions are for use by qualified service personnelonly. To reduce the risk of hazards, do not perform any servicing otherthan that contained in the operating instructions unless you arequalified to do so.To install a wall-mount bracket:1 Lay your TV on a flat, cushioned surface.2 Remove the three screws holding the stand column to the TV,then remove the stand column.3 Insert and lock the standoff screws (provided) into the four holeson the back of your TV, as shown in the following illustration.