Eaton BreakerVisu NZM-XMC-MDISP35-MOD Manual

Also see for BreakerVisu NZM-XMC-MDISP35-MOD: Manual Instruction leaflet Instruction leaflet Instruction leaflet

2 Operator interface2.3 “Start” window14 BreakerVisu 06/16 MN01210001Z-EN www.eaton.comTable 6: Home screen controls (7“ variant)Control ActionThe SmartWire-DT Statistics and Modbus-RTU Statistics boxesprovide basic statistics regarding the connected SmartWire-DT andModbus RTU devices. The number after Devices online indicates thenumber of connected devices that are running, Devices loggingindicates the number of devices with a configured logging function,and Warnings indicates the number of devices that are signaling aproblem.Tap one of the statistics panes to open the corresponding deviceoverview screen (SmartWire-DT: 1 - 8, Modbus RTU: 1 - 8).This button is part of the Modbus RTU Statistics pane.It will be shown when no Modbus RTU devices are detected (after thefirst time the BreakerVisu system is started, for example). When youtap this button, the device will start scanning for Modbus RTU devices.Make sure that all Modbus RTU communication parameters areconfigured correctly before scanning for Modbus RTU devices.Note:In contrast to Modbus RTU device scanning, the BreakerVisu systemwill automatically start scanning for SmartWire-DT devices afterstarting. The reason for this is that the BreakerVisu system does notneed for any SmartWire-DT communication parameters to beconfigured.The BreakerVisu Statistics pane shows basic statisticalinformation, such as: the current BreakerVisu program version,information regarding system resource availability, the date and timewhen the system was last started, and the system time.To set the BreakerVisu system‘s date and time, tap the System timearea inside the pane.A yellow box will appear in the upper left corner whenever aBreakerVisu program notification is generated. This box will show thenumber of notifications, and tapping it will display a list of them.The notifications list (“Notifications”) will show the last 10notifications generated by the BreakerVisu system.Normally, these notifications will refer to the BreakerVisu system‘sstatus and to the use of external system resources (SD card, USB).To delete these notifications, tap the Clear all button.Tapping the languages button will take you back to the welcomescreen, where you can change the system language.