Eaton BreakerVisu NZM-XMC-MDISP35-MOD Manual

Also see for BreakerVisu NZM-XMC-MDISP35-MOD: Manual Instruction leaflet Instruction leaflet Instruction leaflet

15 Appendix15.4 XML configuration for 3rd party devices68 BreakerVisu 06/16 MN01210001Z-EN www.eaton.com15.4 XML configuration for 3rd party devices15.4.1 Example 1Only one specific byte is used: see the sectionbelow.A specific structure must be used for group parameter sections; see, ,, .All groups – even if they are not being used – must be defined. The lengthand offset for the groups not being used must be set to 0. The offset valuesin the XML configuration file start from 1.Specific structure for standard device parameters: The offset is used in aspecific group; the offset starts from 1; 0 for length, offset, and groups forstandard device parameters that are not used; see the section.The end of the device parameter section is indicated by the end of standard parameters>comment in the XML file.After end of standard parameters>up to five additional parameters can be added.DC1PowerXL1190 id="1">2513 id="2">000